9dee6cb2

11.2.2. Removal, dismantling assembly and installation of a rack of a suspension bracket

Removal, dismantling and check

Components of a rack of a forward suspension bracket

1 — Remove the tank of brake fluid
2 — Assembly of a rack
3 — a stabilizer Rack
4 — the Top support of a rack
5 — the Bearing
6 — the Top saddle of a spring

7 — the Damper
8 — the Top casing
9 — the Lower saddle of a spring
10 — the Flexible hose
11 — ABS speed sensor Electrical wiring
12 — the Screw spring
13 — the Shock-absorber


 PERFORMANCE ORDER

  1. Remove a forward wheel.
  2. Turn out a bolt and remove from a shock-absorber bracket holders of a flexible brake hose and electrical wiring of the sensor of speed of ABS.
  3. Disconnect a stabilizer rack from the shock-absorber.
  4. Give two lower nuts of fastening of a rack, but do not remove bolts yet.
  5. At removal of the left rack remove the tank of brake fluid and separate the socket of the sensor of level of brake fluid.
  6. Give three top nuts of fastening of a rack, and then finally give two lower nuts and take out bolts.
  7. Remove assembly of a rack of a forward suspension bracket.
  8. Establish two bolts with nuts in the lower arm of fastening of a rack and clamp it in a vice.
  1. By means of special adaptation squeeze a spring and, holding the top saddle of a spring, give a nut.
  1. Remove the top support of a rack, the bearing, the top saddle of a spring and the top cover.
  2. Pressing and extending a rod of the shock-absorber make sure of smoothness of its course and lack of unusual sounds. At unsatisfactory results of check replace the shock-absorber.

Assembly and installation

 PERFORMANCE ORDER

  1. Install the lower saddle of a spring and a damper on the shock-absorber.
  2. By means of special adaptation squeeze a screw spring and install it on the shock-absorber.

The lower round of a spring has to rest against a groove of the lower saddle.


  1. Establish the top cover and the top saddle of a spring so that the tag not it was turned outside of the car.
  1. Install the bearing and the top support of a rack so that the tag was turned not by it outside of the car.
  2. Tighten a nut of fastening of a spring and remove special adaptation from a spring.
  3. Installation is made upside-down. In conclusion check the angles of installation of forward wheels.