9dee6cb2

11.5.3. Check and adjustments of angles of installation of back wheels

Check

 PERFORMANCE ORDER

  1. Measure suspension bracket height (see the Section Check and adjustment of angles of installation of forward wheels).
  2. Install the car on the measuring stand and check disorder and convergence of back wheels.
  3. If the size of disorder do not conform to requirements of Specifications of the Head Podvesk and steering, check suspension bracket components for existence of damages and wear.

Disorder of back wheels is not regulated.

  1. If the size of convergence do not conform to requirements of Specifications of the Head Podvesk and steering, adjust convergence.

Convergence adjustment

 PERFORMANCE ORDER

  1. Measure distance from a disk of each back wheel to a corner of the clown of adjustment of convergence.
  1. If a difference between the measured distances more than 3.0 mm, weaken a bolt of the clown and turn the clown on the corner demanded for installation of average specification value of convergence.
  1. After adjustment tighten a bolt with effort of 113 Nanometers.