- Insert the screw-driver between a back door the top panel of finishing of glass and wring out the panel from clamps on its perimeter.
- Separate the socket and remove a stoplight of the top level from the top panel of finishing of glass.
- Inserting the screw-driver between a door of a back and elements of finishing of a door, wring out consistently from clamps the top panel, both side and the lower panel.
- Turn out a nut and remove the screen wiper lever.
- Turn out a nut and remove a washer э / the screen wiper motor from the outer side of a door.
- Separate the socket, turn out three bolts and remove э / the screen wiper motor.
- Separate sockets, turn out 4 bolts and remove the back combined lamps with consolidations.
- Disconnect the socket from the lock cylinder, turn out two bolts and remove the cylinder.
- Turn out two bolts, remove the mechanism of control of the lock and disconnect from it a cable.
- Disconnect draft from the lock, give two nuts and remove the lock activator. Separate the socket.
- Separate the socket, turn out 4 bolts and remove the lock.
- Turn out two screws and remove lenses of illumination of registration plate.
- Turn out two nuts and remove the external handle.
- Turn out a nut and wring out the screw-driver an external overlay of a door of a back from clamps.
- Remove the handle for raising of a door.
- Give fixture of loops to a door and remove a door.
- At installation of a door, especially new, it is necessary to adjust its situation.
- For adjustment of a door in the directions give bolts of fastening of loops to a door to the left/to the right and up/down, expose a door in required position and tighten bolts with effort of 8 Nanometers.
- For adjustment of a door in the directions give bolts of fastening of loops to a body up/down and inside/outside, expose a door in required position and tighten bolts with effort of 12 Nanometers. For a reversing of bolts at first:
- Remove a lens of the lamp of the luggage compartment;
- Turn out four bolts, separate the socket and remove the lamp;
- Wring out the screw-driver back section of finishing of a roof from clamps and remove it.
- If necessary adjust position of the drummer of the lock, moving it (tapping with the hammer) at the released fixture outside/inside and up/down. Previously remove the lower panel of finishing of a doorway of a back. Upon termination of adjustment tighten bolts of fastening of the drummer with effort of 23 Nanometers and install the panel.
- In conclusion adjust the provision of a side stopper.
- Installation is made upside-down. Tighten fixture with the required efforts, use new clamps.
- In conclusion of installation adjust provisions of the lever of a screen wiper (see the Section Check of a State, adjustment and replacement of brushes of screen wipers).
|
|
- After installation check that the top point of hit of a stream of the washing liquid on glass was in the shaded area, and the lower point – in a screen wiper scope.
|
|
|
