9dee6cb2

6.1.7. Removal and installation of the fuel tank and fuel lines

Components of installation of the fuel tank and fuel lines

1 — the Coal adsorber
2 — the Adjusting plate of a ventilating tube
3 — Laying
4 — the fuel reserve Sensor
5 — EVAP Hose
6 — the Protective plate No. 3 of the fuel tank
7 — the Sensor of fuel evaporations
8 — the Adjusting plate of a tube of EVAP
9 — the Clip
10 — the Cover of a jellied mouth of the fuel tank
11 — Rings
12 — the Jellied mouth of the fuel tank
13 — the Tube of ventilation of the fuel tank
14 — the fuel cut-off Valve

15 — the Reception tube of the fuel tank
16 — the Reception hose of the fuel tank
17 — the Additional soaking-up fuel hose
18 — the Main tube of the fuel tank
19 — the Clamp of connection of a tube
20 — Assembly of the fuel pump and sensor of a reserve of fuel
21 — the Adjusting plate of a tube of ventilation of the fuel tank
22 — the Fuel tank
23 — the Control valve of level of fuel
24 — the Right bandage tape of the fuel tank
25 — the Left bandage tape of the fuel tank
26 — the Lower central protective plate of the fuel tank
27 — the Right protective plate of the fuel tank
28 — the Left protective plate of the fuel tank


 PERFORMANCE ORDER

  1. Before removal of the fuel tank as much as possible devastate it. Observe precautionary measures (see the Section General information and security measures).
  1. At installation of fuel lines connect them.
  1. Use new laying, tighten fixture with the required efforts.