9dee6cb2

8.7. Removal and installation of assembly of the lever of the selector of the AT modes

Components of assembly of the lever of the selector

1 — the selector lever Handle
2 — a selector lever handle Cap
3 — the selector lever handle Plug
4 — Pruzhina
5 — the selector lever handle Button
6 — the Main switch of the O/D mode
7 — the Lock core
8 — the Panel of indication of the mode
9 — the Cap of removal of blocking of the lever of the selector
10 — the Directing trench of an electrical wiring
11 — the Side cover
12 — the Pin
13 — Pruzhina of manual fixing
14 — the driving mode Switch

15 — the Case of the lower indicator of the mode
16 — a selector lever spring Saddle
17 — the Button of removal of blocking of the lever of the selector
18 — Auxiliary assembly of the lever of the selector
19 — the Damper of vibrations
20 — Assembly of the module of blocking of switching
21 — Draft of switching of the modes
22 — the Plug
23 — a selector lever Insert No. 1
24 — Plastina of the selector lever
25 — the Auxiliary plate of the lever of the selector
26 — the Spring nut
27 — Assembly of a wire of indication of the mode
28 — the Lamp
29 — the Cap


 PERFORMANCE ORDER

  1. Remove the following parts of finishing and the dashboard (see the Body):
    • Lower cover No. 2 of the right part of the dashboard;
    • Panel No. 2 of the right part of the dashboard;
    • Finishing panel of the lower section of the dashboard;
    • Lower section of the dashboard;
    • Lower insert;
    • The lower section of the central dashboard together with the edging;
    • Right and left side covers of a covering of a floor;
    • The lower panel of the central section of the dashboard together with the edging;
    • Lower finishing section central dashboards.
  1. Turn out 4 nuts and disconnect a cable from assembly of the lever of the selector of the AT modes.
  1. Separate three sockets of an electrical wiring and disconnect it from assembly of the lever of the selector.
  2. Remove assembly of the lever of the selector.
  3. If necessary dismantling and assembly of the lever of the AT selector you make Components of assembly of the lever of the selector according to an illustration.
  4. You make installation of assembly of the lever of the selector upside-down.
  5. After installation check serviceability of functioning of the lever of the selector (see the illustration Lever of the Selector of the AT Modes and Description of the Modes).