9dee6cb2

11.3.4. Removal and installation of levers of a back suspension bracket

Components of installation of levers of a back suspension bracket

1 — the Back stretcher
2 — the Holder
3 — the Cross lever No. 1
4 — the Clown of adjustment of convergence of back wheels
5 — the Cross lever No. 2

6 — the Cable of the drive of the parking brake
7 — the Longitudinal lever
8 — Draft of the sensor of adjustment of an inclination of headlights
9 — the Washer


 PERFORMANCE ORDER

  1. Remove a back wheel.
  2. Remove the central and back sections of an exhaust pipe.
  3. Turn out a bolt and remove an arm of a cable of the parking brake from a body.
  4. At the corresponding complete set turn out a nut and disconnect draft of the sensor of adjustment of an inclination of headlights from cross draft No. 2 of a back suspension bracket.
  5. Turn out two bolts, a nut and remove the longitudinal lever of a suspension bracket.
  6. Apply adjusting tags on the clown of adjustment of convergence of back wheels and on a stretcher.
  7. Turn out a bolt and a nut, remove the clown and disconnect cross draft No. 2 from a stretcher.
  8. Turn out a bolt and a nut of fastening of cross thirst No. 2 for stupichny assembly and remove draft.
  9. Turn out a bolt and a nut of fastening of cross thirst No. 1 for stupichny assembly and disconnect from it draft.
  10. Weaken an adjusting bolt of the cross lever No. 1 to a back stretcher.

Do not remove a bolt entirely.

  1. Prop up a back stretcher a jack, turn out 4 nuts, 2 bolts and remove two holders from a back stretcher.
  2. Lower a jack, completely turn out a bolt of fastening of the cross lever No. 1 to a back stretcher and remove the lever.
  3. Installation is made upside-down. In conclusion check and if necessary adjust the angles of installation of back wheels.